Every installation follows the same order. Read the safety notes, gather your tools, then download the guide for your product below.
Support the tipper body with a certified prop before working underneath, and release all hydraulic pressure before disconnecting any hose or fitting.
The four stages are the same for every product. The full detail is in each PDF guide.
Park on level ground, secure the vehicle and check every part against the packing list.
Fit brackets, sub-frame and the main unit, torquing every fixing to specification.
Route and connect hoses, fill the system with the correct oil and bleed out any air.
Run a full cycle, check for leaks, set pressures and complete the handover checklist.
Choose your product to get the PDF for the correct revision.
Cylinder mounting, alignment and hose routing for single and multi-stage tipping cylinders.
Download guideFitting instructions and pressure settings for double acting telescopic cylinders.
Download guideStep-by-step fitting of front-end kits, including sub-frame and pivot brackets.
Download guideInstalling and setting up stabiliser systems on tipper bodies and trailers.
Download guideFitting and testing body props and support equipment for safe maintenance access.
Download guideFull installation of a complete wet kit: pump, tank, valve and pipework.
Download guideMounting a PTO and pump, drive alignment and first-start checks.
Download guideFinal checks, pressure tests and handover record to complete every installation.
Download guideOur technical team can talk you through any step, or arrange on-site support for larger fits.
